This content is intended for general information. The application must be carried out by means of equipment manufacturer instructions, the risk assessment specific to the business and the energy control procedure prepared by authorized persons.
Why do we need a special choice?
Insured separators can mechanically separate a circuit, but each model's arm, cover and lock point are different. The removal of the insurance alone does not replace personal lock.
Data for the product selection
The manufacturer's lock hole, arm geometry, cover lock, polar number and feed direction are documented. If there is no integrated lock point, the external solution approved by the manufacturer or the panel internal procedure will be assessed.
| The area data | Why is necessary? |
|---|---|
| Manufacturers / Model | Key point and instructions for use |
| Photo of the arm / cover | The external apparatus |
| The Value of Remembrance | Authorized Electrical Procedure |
| Alternative food | Identifying the risk of re-heating |
Order of Application
- Stop the load over the normal control.
- Take the separator to the OFF position according to the manufacturer's instructions.
- If there is a personal lock to the integrated lock point, otherwise apply the verified device.
- If necessary, manage insurance according to the authorized electricity staff procedure.
- Verify the energy absence with the test device in the appropriate category; check the test device at a known source before and after the test.
Frequent mistakes
- Insurance is isolated.
- Predicting the direction of food
- Mixing the lock with a separating lock.
- Ignoring the Limits of Living Work
What should be sent to match the offer or product?
The brand-model of the equipment must be sent together, general and close plan photos in a safe state, millimeter measurements, energy type, number of people to work at the same time, and the usage environment. This information reduces the risk of choosing product code according to its appearance alone.
Share your photos and sizes; let us evaluate the product, procedure, training and simulator needs together.